Life at the end of the road

July 8, 2018

A day of ‘many hats’ :-)

Almost 21:00 and that’s me just finished the third plate of herring pasta https://www.lifestylefood.com.au/recipes/17943/mediterraneanstyle-herring-linguine which was basically that recipe but with spaghetti.

DSCN0236

Can’t say that I’ve ever made it but I certainly enjoy eating it, this is one of ‘darling wife’s’ specialities and was the perfect end to a perfect day. A busy day right enough and one with a good variety of tasks, the first of which was to finish off servicing the neighbours wind turbine.

Once upon a time I’d have done this job in half a day but I’ve slowed down a lot these last couple of years and these days I spend half my time looking for things I’ve just put down! Then there are all the times I have to go back to my workshop to collect stuff I’ve forgot. Still, I got there in the end. Even though I’d done all the ‘donkey work’ on Thursday and only had to clean up the slip rings, fit a new brake rope, replace two sheared bolts and raise the turbine, it still took me all morning. And that was with one of my neighbours helping!!

DSCN0215 DSCN0216

The turbine has been running without a brake now for well over a year and has safely seen off several storms with 100mph plus winds. The brake is only really used when lowering the turbine or if it shed a blade or spring or something that made it become unbalanced. The brake could then be applied to prevent further damage. Having said that the Proven/Kingspan turbines are one of the very few that actually have a mechanical brake that can actually stop a turbine in a storm and keep it stopped. Most others have an electrical brake that sorts out the alternator phases, less than ideal and not guaranteed to work. You cannot stop a fast spinning turbine with an electrical brake and if the turbine is stopped and the wind strong enough it will overcome the brake, overheat and melt the core or windings. I speak from experience Sad smile

015017 018

This will be what was left of my Cheap and cheerful Chinese jobby when it was braked in a storm Sad smile

018

7:00am now, got distracted last night by a bottle of Dalwhinnie ‘Winters Gold’

Dalwhinnie Winter’s Gold Bottling Note

Dalwhinnie Winter’s Gold is a 2015 addition to the Highland distillery’s range inspired by the chilly climate up in the remote part of Scotland where their single malt Scotch whisky is distilled – as the label remarks, it was "Crafted by the Cold". It’s made only with spirit that has been distilled between October and March, and interestingly enough, they suggest that you try serving this expression frozen!

Tasting Note by The Chaps at Master of Malt

Nose: Oak spice, pear skins, golden syrup and gristy malt. A touch of peach polish and chewy, sticky toffee. From the freezer it’s fruitier, more green apple, apple sauce, toffee apple, sultana, even redcurrant.

Palate: Very honeyed with warming peppery spices, Big Red cinnamon. From the freezer the honey is kept in check much more, as are the spices. Plenty of apple flesh and orange peel.

Finish: Allspice, nutmeg and smoky malt. From the freezer the finish is more about the spicy cinnamon and peppercorn heat that’s found on the palate at room temperature.

Overall: An assertive, spicy, honeyed Dalwhinnie with enough sweetness and character to be served straight from the freezer (as intended).

I dunno about all that but it was smooth and nice with just a couple of drops of Arnish water in it. I just don’t get all this guff they talk about whisky, wine and football. There seems to be a whole industry that specialize in carp. I’m sure the Dalwhinnie does all of the above but there’s never any mention by the Scotch aficionados about the chlorine taste of tap water Smile I guess you just get used to it, me I think it ruins a good cup of tea or malt.

The Proven Brake

Anyway, back to the wind turbine brake, first thing we had to do was feed the new rope down the tower and for the replacement I chose a heavy braided twine, like the stuff used in a trawl net. One of the problems with the brake rope is that it has a regular ‘lay’(twist) of three strands wound ‘with the sun’ clockwise or righthanded. Braided or multiplat rope has the strands wound and laid in both directions so is much less prone to kinks and twists. Feeding the new rope down the 7m long pole proved a bit of a challenge as it has to go through a 12mm hole in the top of the ‘slip ring’ mounting. This we managed to do using a length of wire rope, pushing it downwards through the slip rings then taping the green twine to it and pulling from the bottom. The twine is then attached to the brake lever at the top of the mast but it must be run through a length of bungee cord or even spring to keep it clear of the shaft when not in use. To operate the brake you wind the cord around the actuation lever at the bottom of the tower then pull the lever downwards. When the brake is released the cord must be removed from the lever and left to hang loose so as not to get twisted. Even so, it generally does Sad smile

 DSCN0217 DSCN0218 DSCN0219

After refitting and sealing the cowlings and checking all the blade bolts (one had snapped and was replaced) the turbine was raised, bolted back down with new M20 bolts and the gin pole removed, job done Smile

They don’t make them like this anymore

The dry spell may just have ended last night with what must have been overnight rain judging by the puddles and wet grass but I doubt it will have done much to replenish the depleted water tanks next door. We were always a little conscious of being economical with water at times like this when we lived at ‘Number 3’ but now there are far more people staying there as Maya and Nikky have the house on Airbnb   https://www.airbnb.co.uk/rooms/8188794 so need far more water than we ever did. Consequently they’ve been pumping ‘Scottish Water’s’ finest from IBC’s into their storage tanks.

DSCN0220 DSCN0221

I had a dedicated pump just for doing this that has all the hall marks of something World War II. I can’t even remember where it came from or who gave me but the little 170W Stuart Turner pump just keeps on going. Having said that it required a little attention yesterday but I soon sorted that with some grease and WD40 Smile 

Panasonic NA-127VB5 washing machine

That sorted I donned my ‘domestic appliance’ engineers hat to try and sort out the washing machine. I gotta say this Panasonic machine has been trouble since day one and I’d never have another. It failed within a few days of getting it home and fair play to Panasonic they offered me a new one. Me being a fool said “ I don’t want a new one, I just want this one fixing”. It is such a PITA getting a washing machine up to Arnish that I couldn’t be bothered taking it back. Anyway an engineer came out and initially blamed it on our DIY electricity, this I told him in no uncertain terms was mince as our electricity is far more stable and reliable than the National Grid and that’s a fact. He then blamed it on my DIY plumbing. At this time the washing machine was in the shed as we were living in the caravan and to be fair to him, the drain was a bit high (or was it low). Anyway, he did some adjustments on the door catch and for the next few months it was fine. Once in the house it failed again and another engineer came out. Can’t remember what the problem was this time but it was OK for a year or two bar the odd error code relating to water pressure (despite us having almost 3bar). Recently it has started stopping mid cycle cos the machine thinks the door is open and the only cure is to restart the cycle and or sit there with your hand pressed on the door till it finishes Sad smile 

This was obviously a switch or adjustment fault so I pulled out the machine and had a look at the switch and catch.

DSCN0222 DSCN0223 DSCN0225

They both seemed fine so I carefully elongated the holes that retain the switch so it would allow the door catch to press the switch deeper so to speak. Well that seemed to work a treat as we have now done three full wash cycles without any problems.

If I didnae have a Landy it would be one of these

DSCN0227

Next it was the mechanics hat again to have a look at the trusty Nissan Patrol of next door’s  that had a broken catalytic converter. I gotta say, if I didn’t have a Land Rover then I’d probably have one of these, the Nissan Patrol is truly ‘built like a tank’. The catalytic converter had broken off at the bottom weld.

DSCN0226

It was a clean break and resting on the front anti roll bar so I reckoned that if I could remove the front track rod then I’d at least be able to get half of it welded.

DSCN0229 DSCN0231

Typically on a 12 year old truck, the track rod end split pins were rusted in and had to be drilled out but that was soon done and the the track rod swung out of they way.

DSCN0232

This enabled me to get a good few dollops of ‘pigeon sh1t’ welding on at least half of it. I could ‘blame my tools’ and tell you the rods were damp (which they were) but the truth is my welding is dubious at the best of times Sad smile

DSCN0233

Once welded I made up a bracket to hold the pipe more rigidly then if it does snap then at least the pipe will stay in the cat and be perfectly serviceable until a new cat can be fitted (but not by me Smile)

Painters hat next

That done it was the time and weather to get on with painting an creosoting the hen shed. I had made a start on this on Friday night when I came back from Inverness. That was after I called in at the Raasay stores for some milk and caught up with my pal Peter

DSCN0207 DSCN0209 DSCN0210

who was also on small single seat transport Smile

It was a perfect evening for painting with just enough breeze to keep the midge away and reduce the temperature to comfortable levels as I had to swap the shorts and T shirt for dark blue overalls.

 DSCN0211 DSCN0212 DSCN0213

The hens retiring to a ‘dangerous area’ whilst I got on with the job.

Well, I got most of it done

DSCN0234

and should now go and finish off.

Advertisements

9 Comments »

  1. You have fair come on with the new hoose paul!!

    Comment by v8mbo — July 8, 2018 @ 10:35 am

    • Aye Robin and I’ve hardly stepped out of it today, been finally sorting out my office which has turned into a bit of skip this last while. Who knows whilst I’m ‘on a roll’ I may even do my VAT return 🙂

      Comment by lifeattheendoftheroad — July 8, 2018 @ 12:21 pm

  2. Morning Paul.
    Looks like your on a roll there with your own bodgems and neighbourly help. Maybe you should have a little holiday 🛥🎣.

    Comment by Polite Scouser — July 9, 2018 @ 7:01 am

    • Funny you should say that Walter, methinks the neighbours would be well up for house and dog sitting too hey 🙂

      Comment by lifeattheendoftheroad — July 9, 2018 @ 7:25 am

  3. Paul, I stopped & spoke to you back in May this year when you were working on the slip, when I spotted you as we started driving back from the ‘end of the road’

    I empathise with this posts “and these days I spend half my time looking for things I’ve just put down!”
    I walk round our bungalow or our garage or the garden trying to remember where I last put down my riggers gloves or the secateurs.
    Or trying to decide which car has the 1/2″ ratchet handle & long extension in it & guessing the wrong one!

    I wish I still had half of your energy to do things still though.

    Good to hear you’ve had some rain it’s still parched down near Bath.

    Please keep on posting, I still find them fascinating & I know how long it takes having edited a monthly club newsletter & migrated it to a web-site for over 20 years. Keeping up to date became a chore!

    Best wishes: Frank & Phyllis

    Comment by Frank Sweeting — July 9, 2018 @ 12:45 pm

    • Hi Frank,
      yes, was good to meet a fellow Forester owner too. I did see you leaving on the ferry but was buried in task on deck 3.

      Cheers, Paul

      Comment by lifeattheendoftheroad — July 9, 2018 @ 1:00 pm

  4. Hi Paul

    I sent a comment in reply to an earlier blog but I used my mobile and the post disappeared. So – I have a postcard of the view of Arnish that you posted. It says Isle of Raasay c 1885 and I bought it in the shop years ago. I haven’t been up to the area where the houses were since the mid-1980s so have no idea what it looks like now. If Hallaig and Screapadal are anything to go by the stones will be fast disappearing. I also noted your Midget with interest. I had a 1965 Midget in about 1973 and I can remember to this day having a heck of a job trying to tune the twin carburettor after a long, hot drive from Dorset to Alness. The hood leaked and my back has never recovered from getting in an out and it wasn’t really a suitable vehicle for carrying a big can of diesel for the Lister – but it was great fun.

    Cheers

    Sue

    Comment by Sue — July 9, 2018 @ 1:33 pm

  5. Hey Paul, I actually own two of the Panasonic NV washing machines – the model I have uses almost no water at all. I’m off grid too, and despite the salt, sea air and being fed off an odd mix of solar thermal spring water mixed with rain water, neither has ever put a foot wrong.

    Comment by Patrick — July 9, 2018 @ 8:28 pm

    • Hi Patrick,

      that’s why we bought the Panasonic Patrick, great reviews, super efficient and I’ve always been a Panasonic fan. Methinks I should have just taken them up on their first offer of a replacement, just insisted they come and swap it. I guess we were just unlucky with this one, perhaps that’s it sorted now, it’s done four washes now without a hitch 🙂

      Comment by lifeattheendoftheroad — July 10, 2018 @ 6:06 am


RSS feed for comments on this post. TrackBack URI

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google+ photo

You are commenting using your Google+ account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s

Blog at WordPress.com.

%d bloggers like this: